Show pagesourceOld revisionsBacklinksBack to top Share via Share via... Twitter LinkedIn Facebook Pinterest Telegram WhatsApp Yammer RedditRecent ChangesSend via e-MailPrintPermalink × Table of Contents NethServer Hardware Requirements Minimum Hardware requirements Hardware Support Hardware RAID UEFI Support References NethServer Hardware Requirements Applies to: NethServer 6 NethServer 7 Minimum Hardware requirements CPU Architecture: 64-bit (x86_64) Memory: 1 GB Disk Space: NethServer 6.x: 8 GB NethServer 7.x: 10 GB Network interface (at least one) An optical drive (i.e. CD-ROM, DVD-ROM) or an USB Stick, for physical server installs. Hardware Support NethServer is compatible with any hardware certified by Red Hat® Enterprise Linux® (RHEL®), listed on hardware.redhat.com Although NethServer can run on non-certified hardware, it is not granted. Hardware RAID On systems with more than one hard drive, NethServer can use software RAID technology to provide data integrity in case of disk failure. If you plan to use the RAID functions provided by your computer's motherboard or attached controller cards, configure them before you begin the installation process. Each active RAID array will appear as one drive within NethServer. UEFI Support UEFI Specification 2.0 or later are supported. Secure Boot technology is supported in NethServer 7 and above. Earlier versions do not support Secure Boot. In order to install NethServer 6.x on UEFI based systems make sure Secure Boot is disabled. References NethServer's Administration Manual Red Hat Enterprise Linux 6 - Installation Guide userguide, ht installation, before installation userguide/hardware_requirements.txt Last modified: 2020/11/20 21:19by Marc